Blooming can occur naturally in rubber products. This can be treated using silicone, which can help reduce the white marks and keep the rubber moisturised, restoring colour.
You will need:
Silicone Spray or Oil and a dry cloth or paper towel. You can get silicone spray at most hardware and outdoor stores, and it's also inside our Merry People Care Kit.
Directions:
Apply a small amount of silicone solution to a clean cloth or paper towel. Start from the top and work down, a section at a time, wiping the cloth over the rubber in a circular motion. Take care to avoid the soles and the neoprene, and give extra attention to areas with more blooming.
Continue this until the silicone is absorbed by the rubber. Leave the shoes to dry completely, and the blooming should have gone. If there are any remaining spots, repeat the process.
The Merry People Care Kit contains all you need to maintain, nourish, protect and prolong the life of your Merry's.
Rubber Treatment (150ml)
A silicone-based spray that moisturises and nourishes natural rubber, helping to maintain its flexibility and extend the life of your boots. Ingredients: Silicone oil, Glycerol, purified water
Buff & Shine Applicator (6ml)
A sponge applicator filled with 100% silicone oil. Use it to add extra shine and a layer of protection to your boots.
Microfibre Cloth
A soft, non-abrasive cloth designed to gently clean and polish the rubber surface.
Cleaning Brush
A firm-bristled brush ideal for removing dirt and debris before cleaning or treating your boots.
Care Kit Steps for Your Merry’s
Follow these Care Kit cleaning instructions to keep your Merry's looking their best and adventure-ready!
Step 1: CLEAN
Remove any excess dirt/debris with a hose, cloth or brush - if needed, you can use some mild detergent. Allow to dry and repeat the process as required. We do not recommend putting your Merry's in the washing machine.
Step 2: TREAT
Shake the rubber treatment bottle well and insert the spray nozzle. Spray a few times on the microfibre cloth and apply evenly to the rubber in a circular motion. DO NOT apply the silicon oil to the sole. Repeat for the other foot and allow to dry completely.
Step 3: SHINE
To activate your Buff and Shine, pump the internal sponge spring a few times and be patient as it makes its way through the sponge. For extra shine and protection, gently rub the Buff & Shine sponge in a circular motion over your Merry People's until a thin coat is evenly applied and allow to dry. Please note the concentrate recipe is mighty, so a little goes a long way!
Caution:
Our silicon solution is non-toxic; however, as with most cleaning products, we recommend using it in a well-ventilated area or outdoors and avoiding breathing in the spray. If the solution gets into the eyes or skin, rinse thoroughly with water. If irritation persists, seek medical attention.
Ensure no solution from the treatment or buffer is applied on the sole, as this can cause slipping. If some ends up on the sole, clean with mild detergent and dry before wearing.
